Skip to content
VIDXIO

Sound Test: Speaker, Headphone & Audio Test

Run a quick sound test on any speaker or headset. Press Left, Right or Both to hear which side is working, then check bass, a subwoofer and surround channels. It works in your browser with no app to install.

Every test sound is made in your browser. Nothing is recorded or uploaded.

How to use the Sound & Speaker Test

  1. 1

    Turn your volume down a little, then press Left, Both or Right.

  2. 2

    Listen: the sound should come only from the side you pressed.

  3. 3

    Try the bass sweep, subwoofer tone and surround buttons to check the rest of your setup.

How this audio test works

Each button plays a short tone made by your browser's built-in audio engine, so nothing has to download. The Left and Right buttons send the tone to one channel only. If you press Left and hear it on the right, your cable, headset or speakers are swapped. If you hear it on both sides, the device or your system may be set to mono.

The test tone is a soft, pulsed beep, which is easier to place in space than a steady hum. You can change its pitch with the Tone frequency slider, from 50 Hz up to 15,000 Hz.

Left right audio test for headphones and earbuds

A left right sound test is the fastest way to check new headphones, a gaming headset or a pair of earbuds. Put them on, press Left, then Right. Each earcup should play only its own side. Many headsets mark L and R inside the band; if the sound is backwards, you're probably wearing them the wrong way round.

If one side is quiet or crackles, wiggle the plug gently while the tone plays. A sound that cuts in and out points to a worn cable or a dirty jack. On Bluetooth earbuds, check the balance slider in your phone's accessibility settings, because it's easy to nudge it to one side by accident.

Speaker test for computers, TVs and cars

The same test speakers routine works for desktop speakers, a laptop, a soundbar or a car stereo connected by Bluetooth. Press Both first to confirm you hear anything at all. Then press Left and Right. On a laptop the two speakers are close together, so listen from a normal seating distance and you'll still hear the side change.

If you only get sound from one speaker, check the balance setting. On Windows it's under Settings, System, Sound, your output device, Properties. On a Mac it's in System Settings, Sound, Output, Balance.

Bass test and subwoofer test

Press Bass sweep to play a tone that slides from 20 Hz to 200 Hz. A good subwoofer should play smoothly through the whole sweep. Most small speakers fade out somewhere between 60 Hz and 100 Hz, which is normal. Listen for buzzing or rattling: that usually means something nearby is vibrating, not that the speaker is broken.

Subwoofer 40 Hz plays one steady low note. Use it to set the sub's level so it blends with your main speakers, or to find a spot in the room where the bass sounds even. Don't play low tones loudly for long, and start with the volume low. Small speakers can be damaged by too much bass.

Surround sound test (5.1 and 7.1)

If your computer is set to 5.1 or 7.1 output, the surround buttons appear after you press any test button once. Each one plays a tone through a single channel: front left, front right, center, subwoofer (LFE), rear left, rear right, and on 7.1 systems, side left and side right. That makes it easy to check that every speaker is plugged into the right output.

If you only see a note about stereo, your browser is getting a two-channel output. Set your sound card or HDMI receiver to 5.1 or 7.1 in your system sound settings, reload the page and try again. Browsers that can't output more than two channels will always show stereo.

Phase check, full sweep and pink noise

Phase check plays noise twice. The first half is normal; the second half flips one channel. With speakers wired correctly, the first half sounds fuller and seems to come from the middle. If the second half sounds fuller, one speaker's red and black wires are swapped.

Full sweep slides from 20 Hz to 20,000 Hz, the usual range of human hearing. Most adults stop hearing the top of the sweep somewhere between 14,000 Hz and 17,000 Hz, so don't worry if it goes quiet before the end. Pink noise is useful for matching the loudness of two speakers by ear.

No sound at all? Try these fixes

Check that the right output device is selected. A monitor, a Bluetooth device or a headset you used yesterday can quietly take over. On a phone, check that silent mode is off and the media volume is up, not just the ringer.

Browsers only start audio after you tap or click, so the first press can take a moment. If a different site is playing sound fine but this one isn't, reload the page. Still nothing? Try another browser to rule out a browser setting.

Is this sound test safe?

Yes. Every sound is generated inside your browser, nothing is recorded, and no microphone access is needed. Keep the volume moderate. High-pitched and very low tones can be tiring or uncomfortable at full volume, and this test is not a hearing exam. If you notice ringing in your ears or hearing changes, please see a doctor or audiologist.

Frequently asked questions

How do I test my speakers?

Press Both to check you hear sound, then press Left and Right. Each side should play only when its button is pressed. Use Bass sweep to test low notes.

Why is only one side of my headphones working?

It's usually a balance setting, a loose plug or a damaged cable. Check your device's left/right balance first, then try another cable or port.

Can I test 5.1 or 7.1 surround sound here?

Yes, if your system is set to a surround output. Press any button once and the channel buttons appear for each speaker.

How do I test my subwoofer?

Press Subwoofer 40 Hz for a steady low tone, or Bass sweep to hear 20 to 200 Hz. Start quiet and raise the volume slowly.

Does this audio test work on iPhone and Android?

Yes. Open the page in Safari or Chrome and tap a button. Turn off silent mode on iPhone if you hear nothing.

Do I need to download anything?

No. The tones are made by your browser, so there's no app and no audio file to download.

Related tools